![]() The bacilli can also enter the bloodstream, causing blood poisoning, or they can affect the lungs, causing pneumonic plague, which can be spread by sneezing and coughing. These swellings start under the armpits and around the groin and spread to other parts of the body. In bubonic plague, the patient gets swellings called buboes. There were many rats in London, and their fleas bit people and gave them the plague. In fact, plague was carried by rat fleas that were infected with plague bacillus (bacteria which cause disease). The beak on his mask is stuffed with spices and dried flowers to sweeten it. Like all physicians, John thought that the plague was passed on by contact whit miasma or bad air. He know that there was a high risk of getting the plague if he stayed in London, but he thought his uniform, which covered every part of his body, would protect him. Soon John was exhausted from treating so many plague victims. Rich Londoners went away, taking their doctors with them, but John had just set up his practice, so did not have any rich patients. John Watson was one of the few doctors who did not leave London when plague broke out in 1665. I also recommend putting plenty of glue on the top seam of the beak.Īfter that, sand the whole beak a bit so that there aren't any sharp edges or angles.Rated 4.00 out of 5 $ 275.00 – $ 295.00 Select options I recommend putting glue on small parts of the bottom half and waiting for that to dry rather than doing the whole thing at once. Remember that this should not sit on the two halves of the beak, but in between them. Press the two halves together and wait for that to dry.Īfter that, it's time to put the bottom piece on. Put hot glue along the top edge of the beak on the inside. (This is why I said to put the glue on the paper and not the cardboard!) Use an X-Acto knife if the glue gives you trouble. Remove the paper and glue from the cardboard. Be sure to do this on the cutting mat!īend the bottom piece so that it matches the curve of the bottom of the beak. If yours is double corrugated (like mine) cut through all but the bottom layer as well. Get the left and right beak pieces and cut along the lines on the paper with an X-Acto knife.Ĭut through the top layer of cardboard and the corrugation but not the bottom layer of cardboard. Be sure to blow through the corrugation to get all the cardboard dust out! Step 4: Assembling the Beak ![]() It seems silly, but I sanded the edges of all the pieces to make sure there are no sharp/rough edges. After that, try to shave off little bits or small chunks as opposed to all of it at once. ![]() Once I had put the glue on and flipped them over, I used a hotel key card to press it on, similar to a decal.Īfter that, you should cut out the pieces roughly rather than precisely. It proved to make the steps ahead much easier. I recommend applying glue to the back of the paper then flipping it over rather than gluing the cardboard. Goggles: doesn't matter, they're circles silly Here are my recommendations for each piece: We should keep this in mind before you glue the pieces on. The direction parallel to the "wiggles" is much easier to fold. The manufacturers do this to make it more structurally sound. When cardboard has a "wiggly" layer in between two flat ones, it is called "corrugated cardboard". ![]() Make sure all the pieces fit on the cardboard before you glue them! Go ahead and plug in the hot glue gun to warm up. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |